Endress+Hauser Waterpilot FMX21 - Overview of Parameters in the Expert Menu

Waterpilot FMX21 Overview of the operating menu
Endress+Hauser 75
13.1 Overview of parameters in the "Expert" menu
The following table lists all of the parameters that can be included in the "Expert"
menu. The page reference indicates where a description of the parameter can be
found in the manual.
Depending on the device version and the parameter configuration, not all submenus
and parameters are available in every device. Information on this can be found in the
parameter description under "Prerequisite".
Expert → System Description
Code definition →  80
Operator code →  80
Expert → System→ Instrument Info Description
Cust. tag number →  81
Device tag →  81
Serial number →  81
Firmware Version →  81
Ext. order code →  81
Order Identifier →  82
ENP version →  82
Electr.Serial No →  82
Sensor serial no. →  82
Expert → System→ Administration Description
Enter reset code →  83
Expert → Measurement Description
Mode →  83
Expert → Measurement→ Basic Setup Description
Pos. zero adjust →  84
Calib. Offset →  84
Damping →  84
Press. eng. unit →  85
Temp. Eng. Unit →  85
Sensor temp. →  85
Expert → Measurement→ Meas. Description
Set LRV →  86
Set URV →  86
Pressure measured →  86
Sensor pressure →  86
Corrected press. →  87
Press after damping →  87