Endress+Hauser Waterpilot FMX21 - Page 76

Overview of the operating menu Waterpilot FMX21
76 Endress+Hauser
Expert → Measurement→ Level Description
Level selection →  88
Output unit →  88
Height unit →  88
Calibration mode →  89
→  89
Empty calib.
Empty pressure →  89
Empty height →  90
Full calib. →  90
Full pressure →  90
Full height →  91
Density unit →  91
Adjust density →  91
Process density →  92
Level before lin. →  92
Expert → Measurement→ Linearization Description
Lin. mode →  93
Unit after lin. →  93
Line-numb: →  93
X-val →  94
Y-val →  94
Edit table →  94
Tank description →  95
Tank content →  95
Expert → Measurement→ Sensor limits Description
Lower range limit →  96
URL sensor →  96
Expert → Measurement→ Sensor trim Description
Lo trim measured →  97
Hi trim measured →  97
Lo Trim Sensor →  97
Hi Trim Sensor →  97
Expert → Output→ Current output Description
Output current →  98
Alarm behav. P →  98
Output fail mode →  98
Max. alarm curr. →  98
Set min. current →  99