Endress+Hauser WirelessHART Fieldgate SWG70 - Adding the Fieldgate SWG70

Commissioning WirelessHART Fieldgate SWG70
38 Endress + Hauser
7.3.2 Adding the Fieldgate SWG70
1. Right-click HART IP Communication and select Add Device:
2. The Add New Device dialog opens:
– Select WirelessHART Fieldgate SWG70 and press OK.
3. The dialog closes and the Fieldgate SWG70 DTM is added below the HART IP node.
4. If the factory IP address (192.168.1.1) or the Ethernet Port (5094) of the Fieldgate
SWG70 has been changed, right-click on the HART IP Communication node and select
Additional Functions => Set DTM Addresses...
– The Set DTM Addresses Dialog opens:
5. Enter the new IP address and/or Ethernet UDP Port number and press Update Changed
Data.
6. Close the dialog – the Fieldgate SWG70 can now be put online.