Endress+Hauser WirelessHART Fieldgate SWG70 - User Interface

Commissioning WirelessHART Fieldgate SWG70
42 Endress + Hauser
7.4 User interface
The Web Server and DTM of the Fieldgate SWG70 are structured in the same manner, so
that the configuration is identical. Before starting, the Web Server must be open, (see
Chapter 7.1.1) or the Online parameterization dialog of the DTM must be open, see
(Chapter 7.3.3). The user interface is structured as follows:
Fieldgate configuration Chapter 8 Modbus OPC EtherNet/IP
Identification Chapter 8.1 X X X
Wireless Communication Chapter 8.2 X X X
Basic Setup and
Advanced Setup
Chapter 8.2.1
and
Chapter 8.2.2
XXX
Operating Modes Chapter 8.2.3 X X X
Interfaces (wired communication) Chapter 8.3 X X X
Ethernet Chapter 8.3.1 X X X
Serial (RS-485) Chapter 8.3.2 X X X
Protocols (wired communication) Chapter 8.4
Modbus via Ethernet or RS-485 Chapter 8.4.1 X
EtherNet/IP via Ethernet Chapter 8.4.2 X
HART via Ethernet or RS-485 Chapter 8.4.3 X X X
AMS via Ethernet Chapter 8.4.4 X X X
Diagnostics Chapter 9 X X X
Identification Chapter 9.1 X X X
Wireless Communication Chapter 9.2 X X X
Overview Chapter 9.2.1 X X X
Details Chapter 9.2.2 X X X
Burst Lists Chapter 9.2.3 X X X
Topology View (Diagnostics) Chapter 9.2.4 X X X
Wired Communication Chapter 9.3 X X X
Overview Chapter 9.3.1 X X X
HART Chapter 9.3.2 X X X
Engineering Chapter 10 X X X
Instrument List Chapter 10.1 X X X
General Chapter 10.1.1 X X X
Creating and editing an Instrument List Chapter 10.1.2 X X X
Topology View (Engineering) Chapter 10.2 X X X
Configuring Modbus Chapter 10.3 X X
Modbus Settings Chapter 10.3.1 X
Input Status Chapter 10.3.2 X
Input Register Chapter 10.3.3 X
Configuring a WirelessHART OPC server Chapter 10.4 X
System architecture of an OPC WirelessHART network Chapter 10.4.1 X
Configuring the WirelessHART OPC server with "WirelessHART
Fieldgate OPC Configurator"
Chapter 10.4.2 X
Description of the WirelessHART Fieldgate OPC Configurator Chapter 10.4.3 X
Configuring bursts using the WirelessHART OPC server Chapter 10.4.4 X
EtherNet/IP configuration Chapter 10.5 X
Setting up an EtherNet/IP connection Chapter 10.5.1 X
Assigning data exchange connections via HART descriptors Chapter 10.5.2 X
Burst commands for cyclic data exchange Chapter 10.5.3 X
Integrating SWG70 into a PLC via EtherNet/IP Chapter 10.5.4 X
Cyclic data exchange via the ControlLogix® controller system Chapter 10.5.5 X
Connection parameters for cyclic data exchange Chapter 10.5.6 X
Diagnostic bits in cyclic data exchange Chapter 10.5.7 X
Additional Functions Chapter 11 X X X