Enduro EM303A+ - Page 45

ENDURO
®
EM303A
+
39
Ref: EM303A
+
-UM-TKI-0116-Rev.A.
Check if there is any distortion signal (other transmitter, high power cables, Wifi etc.) that disturbs a good
communication between remote control handset and control unit. If there is no good communication between
the control unit and remote control handset, the manoeuvring system will not function and the green LED on
remote control handset is blinking.
In general, all error messages will reset automatically after one minute. If this is not the case, reset the
electronics of the manoeuvring system by switching off the manoeuvring system via the isolation switch and the
remote control handset for at least 15 seconds and then turn them on again.
Roller will not turn, spindle rotates freely:
The motor or gear is broken, please contact your EN
DURO
®
supplier.
In case of any doubt, please call your EN
DURO
®
supplier.