14
Mechanical Troubleshooting
The repair steps marked in Italic below must be carried out only by a qualified technician. Please contact your point
of sales for further instructions. INTERSPORT declines all responsibility in case of repairs that have been carried out by
unqualified personnel.
Problem Solution
Computer display does not work at all
or partially.
1. Check power supply.
2. Check cable connections.
3. Replace the computer.
Pulse does not work. 1. Clean hand pulse plates.
2. Check cable connections.
3. Check if pulse cable is plugged-into computer.
4. Moisten your palms.
5. Let another person check the pulse function, on a small percentage of
the population the hand pulse is not readable.
6. Replace hand-pulse plates.
7. Replace computer.
What does the POLAR® logo mean? ENERGETICS products that carry this logo can be used with a uncoded
chest belt.
No speed signal. 1. Check the upper cable connections.
2. Check if the speed sensor is in the right position.
3. Replace the speed sensor.
4. Replace the computer or power board.
The upright post shakes. 1. Loose upright post screws.
2. Re-insert screws/washers and tighten screws equally.
The home fitness equipment shakes. 1. Use the rear stabilizer height adjustment to level out any unevenness.
2. Move the equipment to a different place and check if the problem still
persists.
The home fitness equipment creates
abnormal noises.
1. Check the fit of the stabilizer bolts.
2. Check the end caps.
3. Check if the tension of the belt is too high.
4. Check roller bearings, drive motor, incline motor (if applicable).
To Next Page
Loading...
