8
starter to operate. This isn’t a fault, it is just the jump
starter analysing the vehicle’s battery condition, for it
to work effectively.
5. Once the vehicle has started and the LED (C)
flashes green, disconnect the black and the red
clamps first from the vehicle’s battery, then remove
the blue connector from the jump starter.
6. Replace the protective cover over the ‘Engine Start’
port (C).
WARNING
1. Disconnect the jump starter within 30 seconds of
starting your vehicle.
2. Always connect the red clamp first, never both red
and black clamps at the same time.
3. Do not dismantle the jump starter.
To Next Page
Loading...