3
RSL Torque Wrench
1 Introduction
Overview
The Enerpac RSL torque wrench is designed for
controlled tightening and loosening of fasteners
in industrial bolting applications. The RSL torque
wrench features a low profile cassette, compact
drive unit and integrated reaction arm, making
it ideal for use in locations where workspace is
limited.
Interchangeable RSL hexagon and square drive
cassettes are available in a large assortment of
both metric and imperial sizes to suit specific
customer requirements.
The RSL torque wrench can be used with a wide
range of Enerpac bolting pumps. Electric, air
pumps, and battery powered are available (sold
separately).
Delivery Instructions
Upon delivery, all components must be inspected
for damage incurred during shipping. If damage
is found, the carrier should be notified at once.
Shipping damage is not covered by the Enerpac
warranty.
Warranty
• Enerpac guarantees the product only for the
purpose for which it is intended.
• Refer to the Enerpac Global Warranty document
for terms and conditions of the product warranty.
Any misuse or alteration invalidates the warranty.
• Observe all instructions as communicated in
this manual.
• When replacement parts are needed, use only
genuine Enerpac replacement parts.
Conformance to National and International
Standards
Enerpac declares that the product(s) have been
tested and conforms to applicable standards and
the product(s) are compatible to all EU and UK
Requirements.
Copies of the EU Declaration as well as the UK
Self-Declaration are enclosed with each shipment.
These tools conform with
the requirements for
CE and UKCA.
•RSL1500 •RSL3000 •RSL5000 •RSL8000
•RSL11000 •RSL19000 •RSL28000
2 Safety
Read all instructions carefully. Follow all
recommended safety precautions to avoid
personal injury as well as damage to the wrench
and/or damage to other property. Enerpac cannot
be responsible for any damage or injury from
unsafe use, lack of maintenance or incorrect
operation. Do not remove warning labels, tags,
or decals. In the event any questions or concerns
arise, contact Enerpac or a local Enerpac
distributor for clarification.
If you have never been trained on high-pressure
hydraulic safety and Hydraulic Torque Tools,
consult your distributor or service center for
information about Enerpac Hydraulic Safety
Course.
This manual follows a system of safety alert
symbols, signal words and safety messages
to warn the user of specific hazards. Failure to
comply with these warnings could result in death
or serious personal injury, as well as damage to
the equipment or other property.
The Safety Alert Symbol appears
throughout this manual. It is used to alert
you to potential physical injury hazards.
Pay close attention to Safety Alert Symbols and
obey all safety messages that follow this symbol
to avoid the possibility of death or serious
personal injury.
Safety Alert Symbols are used in conjunction
with certain Signal Words that call attention to
safety messages or property damage messages
and designate a degree or level of hazard
seriousness. The Signal Words used in this
manual are DANGER, WARNING, CAUTION and
NOTICE.
Indicates a hazardous situation that, if
not avoided, will result in death or serious personal
injury.
Indicates a hazardous situation that,
if not avoided, could result in death or serious
personal injury.
Indicates a hazardous situation that,
if not avoided, could result in minor or moderate
personal injury.
Indicates information considered
important, but not hazard related (e.g. messages
relating to property damage). Please note that the
Safety Alert Symbol will not be used with this
signal word.
To Next Page
Loading...
Need help?
General
