Name: enertik BC-F20HWR2-200L
Brand: enertik
Rating: 4 (1 reviews)

Questions and Answers:

Rachael CherryAug 7, 2025

What to do if my enertik BC-F20HWR2-200L shows E02 error?

K
Kimberly BradleyAug 7, 2025
If your enertik Water Heater displays the error code E02, it indicates a low-pressure protection issue. This could be due to several reasons: * The low-pressure switch connection might not be secure, so check the connection. * The pressure switch itself may be faulty, requiring replacement. * There might be a blockage or leakage in the refrigerant system, which needs inspection or repair. * The refrigerant level might be insufficient, requiring more refrigerant to be added. * In rare cases, the PCB (Printed Circuit Board) could be damaged and needs replacement.

Alyssa FrederickAug 11, 2025

What to do if my enertik BC-F20HWR2-200L Water Heater shows E01 error?

J
Jason PenaAug 11, 2025
If your enertik Water Heater displays the error code E01, it indicates a high-pressure protection issue. Here's what might be happening and what you can do: * The high-pressure switch connection might be loose, so check to ensure it's properly connected. * The pressure switch itself may be broken and need replacing. * The refrigerant system might be blocked, requiring a check. * There may be too much refrigerant, in which case the amount needs to be reduced. * The PCB (Printed Circuit Board) could be broken, requiring replacement.

Model

BC-F20HWR2-200L

enertik BC-F20HWR2-200L Installation Instructions Manual

Other manuals for enertik BC-F20HWR2-200L