Page 5 Page 6
93-01651-01 Rev01 Page 1
Copyright © 2016 Enlighted Inc. All rights reserved.
All other brand or product names are trademarks of
their respective companies or organizations.
Technical Support
For questions regarding the installation or operation of
this product, contact Enlighted
Technical Support: support@enlightedinc.com
Company Contact Information
Location: 930 Benecia Ave, Sunnyvale, CA 94085
Phone: +1.650.964.1094
Web: enlightedinc.com
Universal Mounting Case
Installation Instructions
Model: CASE-FS-D22
Universal Mounting Case
Shipped Components
• Enlighted Universal Mounting Case
• Enlighted Mounting Bracket
• ½ inch Chase Nipple and Locknut
• 2 nos. #8 Anchor Screws (Drywall
®
mount)
• 2 nos. #8 Metal Self-tapping Screws (Fixture mount)
Items you may Need
• 400BAC Wiremold
®
Conduit
• 18” AWG wire
Tools you may Need
• ½” knockout set
• Hand drill
• Wire stripper
• Pliers
• Phillips screwdriver
Section 3: Mounting without Bracket
Step 2: Using your thumb or
pliers, push and remove the
knockout of the UMC’s front
case.
Step 3: Insert the ½” Chase
Nipple through the knockout
hole of the UMC’s front case.
Step 4: Insert the sensor into
the UMC case pulling the
cables through the Chase
Nipple. Make sure the lens and
antenna are visible through
the hole in the front.
Step 5: Slide to close the
UMC back cover.
Refer to the design guideline to ensure that the condition is
met. Complete Steps 1, 2, and 3 of Section 1: UMC
Installation before following the procedure below.
Step 6: Mount the UMC to
the fixture by tightening the
Chase Nipple with the
locknut.
Section 4: Wiring the Cables to the LED Driver
To
lamps
From Mains
To Enlighted
Sensors
Step 1: Wire the other end of
the sensor cable to the LED
driver’s XSR connections.
After mounting, rotate the UMC to the required direction and
turn the power on.
Section 5: Rotating the UMC
Step 1: Remove ½” fixture
knockout.
To Next Page
Need help?
General