ENSONIQ ASR-X PRO

To Next Page

To Previous Page

Insert Effect Parameters

ENSONIQ ASR-X Pro UserÕs Guide 33

→CC

Combines a plate reverb with a stereo chorus.

Decay 0.0sec to 10.0sec Controls the amount of time it takes for the

reverberation to decay after the input signal stops.

HF Damping 100Hz to 21.2kHz Controls the rate of attenuation of high frequencies in

the decay of the reverberation. Increasing the value of

this parameter will gradually filter out (dampen) more

and more high frequency energy.

HF Bandwidth 100Hz to 21.2kHz The high frequency bandwidth acts as a low pass filter

on the signal going into the reverb, controlling the

amount of high frequencies that will pass into the effect.

The higher the setting, the more high frequencies are

allowed to pass.

Diffusion 1 0 to 100 Smears the input signal transients, to diffuse and

smooth the sound. Lower values will cause impulse

sounds to appear as a series of discrete echoes, while

higher values tend to increase the smear (smoother

sounding with fewer discrete echoes). We recommend

settings of 50 for starters.

Diffusion 2 0 to 100 This parameter, similar to and in series with Diffusion 1,

performs the same way but controls lower frequency

ranges. Experiment with different levels between the

diffusion parameters to find the settings that are right

for your source.

Definition 0 to 100 Controls the rate at which echo density is increased with

time. Setting this parameter too high can cause the echo

density to build at a rate which exceeds the decay rate.

Chorus Mix Full Dry to Full Wet Controls the dry/wet mix of the chorus.

LFO Rate 1/1 Sys to 1/32 Sys, 0.0Hz

to 20.0Hz

Controls the rate of pitch modulation to the chorus.

LFO Shape Triangle, Sine, Sawtooth,

Square, Asym, 16-Step, 8-

Step, 4-Step

Determines the shape that the LFO will use for pitch

modulation.

LFO Phase -180deg to +180deg Controls the relative phase between left & right LFOs.

Chorus Depth 0.0ms to 25.0ms Controls the amount of modulation.

Chorus Center 0.0ms to 50.0ms Controls the delay times within the chorus. Adjusting

this parameter will change the tonal character of the

chorus.

System

Feedback

-99% to +99% Controls the amount of feedback applied from the

output of the chorus to the input of the reverb.

→FF

This insert effect features a plate reverb with a flanger effect.

Decay 0.0sec to 10.0sec Controls the amount of time it takes for the reverb to

decay after the input signal stops.