through the effects processor to the main stereo outputs.
(You may want to change this.)
You have now selected the BUS 2 output of the OEX-6 to play WS
16.
You should now be able to hear sound out
of
those outputs.
for
some reason you do not, check the following:
If
l
Is the OEX-6 connected properly?
l
Did you follow the above steps carefully?
l
Are properly working audio cables connected to the
outputs
of
the OEX-6?
At this point you could adjust the volume, panning, and other
parameters of the wavesample (layer, instrument) to meet your
needs.
After adjusting parameters you can save them as a part of the
instrument. So if you like the setting you have created save it. See
section Section 7
-
Voice Parameters of the Musician’s Manual for
more on output programming.
Use the above example to route an instrument or layer to the
OEX-6. Remember edits made to the output (AMP) page are
saved with the sound.
3) Assigning a Track to the OEX-6
You can also route signal to the OEX-6 by using the EDIT/
TRACK page. This method overrides the previous example and
requires the results to be saved as a part of a bank and not an
individual instrument.
l
Follow step one above.
l Select desired track.
l Press Edit then Truck. You should now scroll left/right
until you see the output page. It looks like this:
OUT= WAVESAMPLE
Please note that depending on the previous configura-
tion wavesample could be replaced by AUX 1, BUS 2,
BUS 3, FX 1, or ROTATE. Using the same example as
To Next Page
Loading...