ENSONIQ OEX-6sr - Setting Up the OEX-6 sr; Mounting Methods: Rubber Feet & Velcro

OEX-6sr Operation Manual
ways; at the WaveSample level or at the track level.
Setting-up the OEX-6sr
Although you can set-up your OEX-6sr any way you like, we
suggest using one of these practical mounting methods:
Rubber Feet Only Mount
Here’s what you’ll need to get started:
1)
2)
l OEX-6sr Output Expander
l Six foot connection cable (cable lengths of 10 feet or
longer may not give optimal results, and are not
recommended by ENSONIQ)
l Four rubber feet (included)
Apply rubber feet to the bottom of the
OEX-6sr.
Place the OEX-6sr in the
position of your choice,
such as the recess over the
ASR/EPS- 16 PLUS logo,
or on the floor beneath
your keyboard stand.
Velcro Only Mount
Here’s what you’ll need to get
started:
1)
2)
3)
l OEX-6sr Output
Expander
l Six foot connection cable (cable lengths of 10 feet or
longer may not give optimal results, and are not
recommended by ENSONIQ)
l Two strips of adhesive velcro (included)
Position the
OEX-6sr on the top
right corner of the
ASR/EPS-16
PLUS. It fits comfortably in
the recess directly over the
ASR/EPS-16 PLUS logo.
Mark the position with
masking tape (not included).
Place the “furry” side of the
two adhesive velcro strips
2