ENSONIQ OEX-6sr - Microphone Stand Mounting; Mic Flange Mount Setup

OEX-6sr Operation Manual
1) Position the OEX-6sr on the optional rack shelf, aligning the
two outer holes on the bottom of the
OEX-6sr with a pair of
holes on the rack shelf. The OEX-6sr can be mounted
facing either way, but we suggest facing the Output jacks of
the OEX-6sr towards the front of the rack shelf. This will
aid in quick changes for recording purposes.
2) Attach the OEX-6sr to the rack shelf using two (included)
screws.
3) Once the OEX-6sr is attached to the rack shelf, you can
mount the shelf into a rack mount housing.
Mic Flange Mount
Here’s what you’ll need to get started:
1)
2)
l OEX-6sr Output Expander
l Six foot connection cable (cable lengths of 10 feet or
longer may not give optimal results, and are not
recommended by ENSONIQ)
l Three 6-32 x 3/8 SEM machine screws (included)
l Optional microphone stand hardware
l Optional flange. The following 5/8”-27 F. microphone
stand mounting flanges are compatible with the OEX-6sr:
l ATLAS/SOUNDOLIER models #AD- 11 B (chrome)
and #AD-
11 BE (ebony)
For the dealer nearest you, contact:
ATLAS/SOUNDOLIER
Atapco Security & Communications Group
1859 Intertech Drive
Fenton, MO 63026
USA
telephone: (800) 876-7337
(3 14) 349-3 110
Turn the OEX-6sr upside
OEX-6sr can be positioned
in a variety of ways. One
5