ENSONIQ ZR-76 - Page 53

To Next Page

To Previous Page

Chapter 3ÑGlobal Settings

ENSONIQ ZR-76 Musician's Manual44

4. Turn the Parameter knob until the display shows:

System Pitch:

PitchBendMode= Prog

The current PitchBendMode value

The global PitchBend Mode parameter can be set to:

¥ NormalÑall notes that are playing will be affected by Pitch Bend messages.

¥ HeldÑonly notes which are being physically held down will be affected by Pitch Bend messages.

¥ ProgÑPitch Bend messages will affect notes according to each soundÕs programmed pitch bend

mode.

5. Use the Value knob to set the PitchBend Mode to the desired value.

There may be a time when you need to use the ZR-76 with an instrument that just canÕt be tuned, or

when you have to deal with musicians who donÕt want to retune for one reason or another. The tuning

parameter allows you to adjust the ZR-76Õs tuning to match other instruments. The ZR-76 defaults to

A=440, with an equi-tempered pitch table.

When you change any system setting, ZR-76 operations will pause momentarily

to store your settings into FLASH memory.

1. Press the System button.

2. Turn the Parameter knob until the display shows:

System/MIDI:

Alter system pitch?

3. Press Yes if youÕd like to change the current system pitch settings. Press No to cancel the procedure.

4. Turn the Parameter knob until the display shows:

System Pitch:

Fine Tuning= Ocents

The current fine tuning value

5. Use the Value knob to set the amount that you want to raise or lower the pitch. The pitch can be

lowered or raised from -50 to +49 cents.

Setting the ZR-76 to 0 cents is equivalent to A=440. 100 cents is the equivalent of a

semitone.

Other manuals for ENSONIQ ZR-76