ENSONIQ ZR-76 - Page 59

Chapter 3ÑGlobal Settings
ENSONIQ ZR-76 Musician's Manual50
A CV pedal plugged into this jack can also act as a volume pedal, controlling the overall loudness of your
ZR-76. The System CVPedal parameter determines whether the CV pedal will act as a modulator, a
volume pedal, or as one of the special System Controllers (see below).
PP
PP
ee
ee
dd
dd
aa
aa
ll
ll
//
//
CC
CC
VV
VV
SS
SS
pp
pp
ee
ee
cc
cc
ss
ss
::
::
3-conductor (Tip=control voltage input, Ring=510 ohm resistor to +5 Volts,
Sleeve=ground). 36 KOhm input impedance, DC coupled. Input voltage range=0 to 3 volts
DC. Scan rate=32mS (maximum recommended modulation input=15 Hz). For use with an
external control voltage, use a 2-conductor cable with the voltage on the tip and the
sleeve grounded.
When you change any system setting, ZR-76 operations will pause momentarily
to store your settings into FLASH memory.
TT
TT
oo
oo
AA
AA
ss
ss
ss
ss
ii
ii
gg
gg
nn
nn
aa
aa
FF
FF
uu
uu
nn
nn
cc
cc
tt
tt
ii
ii
oo
oo
nn
nn
tt
tt
oo
oo
tt
tt
hh
hh
ee
ee
CC
CC
VV
VV
PP
PP
ee
ee
dd
dd
aa
aa
ll
ll
1. Press the System button.
2. Turn the Parameter knob until the display shows:
System/MIDI:
Set up foot control?
3. Press Yes if youÕd like to change the current foot switch settings. Press No if youÕd like to cancel the
procedure.
4. Turn the Parameter knob until the display shows:
Foot Controls:
CVPedal=Volume #007
i
The current CV pedal assignment
You can set the CV pedal to send values to any aspect of a sound or effect that is modulated by a