ENSONIQ ZR-76 - Page 62

To Next Page

To Previous Page

Chapter 3ÑGlobal Settings

ENSONIQ ZR-76 Musician's Manual 53

4. Turn the Parameter knob until the display shows:

MIDI Settings:

ClockSource=Internal

The current Clock Source value

The ClockSource parameter can be set to:

¥ InternalÑto use either the ZRÕs Drum Machine or 16 Track Recorder as the master clock source

¥ MIDIÑto use external MIDI clocks as the timing source, and to enable the 16 Track Recorder's

response to MIDI Song Position Pointer messages

5. Turn the Value knob to set Tempo ClockSrc to the desired setting.

Whenever ClockSource is set to MIDI, the tempo and sequence location displays in

the Drum Machine and 16 Track Recorder show that the ZR is synchronized to an external

MIDI device.

The ZR-76 is capable of transmitting MIDI clocks to other MIDI devices, so that you can use your ZR as

the master timing reference in your setup. When this feature is enabled, the ZR-76 will transmit MIDI

Song Position Pointer, Start, Stop and Continue messages when you press the appropriate button in the

16 Track Recorder.

You can turn this feature on or off using the Xmit MIDI Clocks parameter.

When you change any system setting, ZR-76 operations will pause momentarily

to store your settings into FLASH memory.

1. Press the System button.

2. Turn the Parameter knob until the display shows:

System/MIDI:

Edit MIDI settings?

3. Press Yes if youÕd like to change the current MIDI settings. Press No if youÕd like to cancel the

procedure.

4. Turn the Parameter knob until the display shows:

MIDI Settings:

Xmit MIDI Clocks= On

The current Xmit MIDI Clocks value

Other manuals for ENSONIQ ZR-76