Routing Protocol Configuration Command Set
Configuring VRRP
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-105
13.2.6.11 ip vrrp authentication-key
Use this command to set a VRRP authentication password on an interface.
ip vrrp authentication-key password
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command clears VRRP authentication:
no ip vrrp authentication-key
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the VRRP authentication password to “vrrpkey” on VLAN 1:
password Specifies an authentication password. Text string can be 1 to
8 characters in length.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip vrrp authentication-key vrrpkey
To Next Page
Loading...
