ENVO LYNX-20 FOLDING EBIKE EASY INSTALLATION GUIDE | VERSION 1.0 1
LYNX-20 FOLDING EBIKE
EASY INSTALLATION GUIDE
ASSEMBLY INSTRUCTIONS
1. GENERAL REQUIREMENTS
ENVO Lynx-20 components need to be installed professionally, as they require ne-tuning and
adjustment after installation. It is highly recommended to get help from an experienced mechanic,
refer to your local ENVO dealer (a list of ENVO dealers can be found on our website). If you choose
to do it yourself, please make sure you refer to the online guides on envodrive.com for your own
safety.
Required tools: 1) Allen key set 2) Cutter/Scissor 3) 15mm wrench
2. UNBOXING
• Open the box from the top side
• Be careful when pulling the frame out and protect the cables from getting tangled or damaged
3. UNPACKING
• Carefully remove all packaging wrap
• Cut all zip ties
4.1. UNFOLDING
• Unfold the handlebar/stem by simply pulling it up into place Figure 4A
• Pull up on the clamp to secure the stem and secure the clamp with the lock ring
• Adjust handlebar to desired angle by loosening the handlebar clamp. Make sure the clamp is
firmly secured Figure 4B
• Adjust seatpost to desired height Figure 4C
4. UNFOLDING/FOLDING
Figure 4A Figure 4B Figure 4C
To Next Page
