38
EN Installation
5. Installation
This chapter shows how to install the mill wheel together with a compatible sauna heater.
5.1 General installation instructions for the installation
All electrical installations laid inside the cabin must be suitable for silicone cables and a tempera-
ture of at least 140°C. A 4-core heat-resistant cable is required for the connection (included in the
delivery contents).
All lines must be routed in such a way that they are well-protected, e.g. in a cable duct. EOS recom-
mends laying all connecting cables through a bendable metal tube connected to the protective
conductor.
NOTICE
The control unit may only be installed outside the sauna!
NOTICE
The mill has a xed water connection and requires a permanent water supply.
WARNING
Fire hazard
Prior to the installation of all individual components all protective foils must entirely be
removed.
To Next Page
Loading...