50
EN Remote control button
7. Remote control button (optional)
7.1 Wall mounting
1. Preferably chose the outside wall of the cabin for mounting.
2. Cut the two adhesive tape strips supplied into two equally long parts (40 x 20 mm).
3. Now t the two adhesive tape strips at the rear of the button housing at the same distance.
4. Press the button housing with the axed adhesive tape against the wall in the desired place
of mounting.
5. Now pull the button back o again and press the remaining adhesive tape strips down.
6. Then ax the button again and lead the connection line to the controls
NOTICE
Installation location - only outside the cabin.
To Next Page
Loading...