Overheat protector will shut of the unit when it exceeds 167°F
CE certified
Operating Instructions:
1. Make sure the power switch is at OFF position and the vehicle engine is
running.
2. Remove the dust cap from the tire valve, and then attach the air chuck to the
tire valve stem, and screw onto tire’s valve stem.
3. Plug the power cord into a 12V cigarette lighter socket.
4. Press (M) button to choose the display unit. (4 units available: PSI, KPA, BAR,
KG/CM). Press (-) or (+) button to set the desired pressure, and then wait until it
stops flashing.
5. Turn on the power switch. The compressor will automatically stop inflating once
the desired pressure is reached.
6. When the desired pressure is reached, turn OFF the power.
7. Unscrew the valve connector, place the tire valve dust cap back to the tire &
disconnect the power cord from a 12V cigarette lighter socket.
Product ID: 707129800176
To Previous Page
Loading...