For use in normal environments.
R27-RF - 2 Zone RF Programmer
Installation Instructions
Page 1 of 2
Before commencing any work on the electrical connections, you must rst disconnect the programmer
from the mains. None of the 230V connections must be live until the installation has been completed and
the housing is closed. Only qualied electricians or authorised service sta are permitted to open the
programmer. Disconnect from mains supply in the event of any damage to any buttons.
There are parts that carry mains voltage behind the cover. The programmer must not be left unsupervised
when open. (Prevent non specialists and especially children from gaining access to it.)
If the programmer is used in a way not specied by the manufacturer, its safety may be impaired.
Ensure that this wireless enabled programmer is installed 1 metre from any metalic object, television, radio
or wireless internet transmitter.
Prior to setting the programmer, it is neccessary to complete all required settings described in this section.
Never remove this product from the electrical baseplate. Do not use sharp tools to push any button.
CAUTION! Installation and connection should only be carried out by a qualied
person and in accordance with national wiring regulations.
This programmer can be mounted in the following ways: 1. Directly wall mounted 2. Mounted to a recessed conduit box
This 2 zone RF programmer is designed to provide
ON/OFF control for 2 zones, with the value added
application of in built frost protection.
Important: Keep this document
1
3
4
5 6
2
Type
EN60730
1C
IP20
EN60529
50
°C
0
122
°F
32
5-95%RH
160.5
100
20221107_R27-RF_InsIns_PK
EPH Controls Ireland
technical@ephcontrols.com www.ephcontrols.com
EPH Controls UK
technical@ephcontrols.co.uk www.ephcontrols.co.uk
To Next Page
Need help?
General
