USER GUIDE
PAGE 7
The V‐Series Rudder
Rudder Operation
The V‐Series rudder is operated with the two toe pedals on top of the carbon footboard.
This “gas pedal” type system is extremely easy to operate. To turn the bow of the surf
ski to the right, simply push the right toe pedal forward. To bring it back to center,
push the left pedal forward until the two pedals are back in line vertically (and vice
versa to point the bow to the left.)
While underway the rudder does not lock in a fixed center position. To keep the rudder
centered and “neutral”, keep equal pressure on the toe pedals, keeping them both in
line. This is a natural and comfortable position, and allows for instant corrections while
paddling.
Do not over‐correct with your rudder! V‐Series surf skis are surprisingly
maneuverable, and the rudder is easy to use and very responsive. While underway,
start your corrections in small increments, with small adjustments to the rudder, and
then correct accordingly. Pushing the pedals back and forth aggressively will only
frustrate you and keep the ski from finding the line you want!
Rudder Options & Initial Rudder Installation
V‐Series surf skis are sold with either Epic’s surf, weedless, universal or roughwater
weedless rudder depending on where the ski is purchased. All rudder designs are
installed the same way. New surf skis are sent from Epic with the following materials
included: rudder, rudder pin, spreader bar (with rudder lines attached), and an allen
wrench. The smaller items are shipped inside the rudder access cover (photo 4) or
inside the Velcro pouch on your rudder flag. The rudder is wrapped separately for
protection, and then secured and shipped in the footwell.
Photo 3. V‐Series – installed Universal rudder and small weed guard
Photo 4. V‐Series – rudder access cover with materials as shipped: allen wrench,
spreader bar, rudder pins
To Next Page
Loading...