eProdigy Bikes Logan - Front Fender Installation

10 '30/5'&/%&3*/45"--"5*0/
www.eProdigyBikes.com
'30/5'&/%&3 INSTALLATION
Use a 3mm Allen key, 5mm Allen key, and a 10mm/ Crescent wrench
Place the fender in the fork.
Secure the fender mount
in the highest position on
the mounting tab
Front fender attaching hardware
has been pre-assembled onto the
fork. Loosely holding the light in place
Remove the nut
from the fork
crown
4
Tighten the bolt and
nut with a 5mm Allen
key and a 10mm
wrench
5
6
Note
At this point you can
adjust the position
of the light to the
desired angle
c
c
Back View