Epson Stylus Pro 11880
10/07 Epson Stylus Pro 11880 - 5
Replacing Ink Cartridges
The easiest way of checking ink levels is from the control
panel LCD display. The numbers below the ink icons on the
LCD display correspond to the 9 ink cartridge slots on the
printer (as listed on page 2). The icons show the approximate
amount of ink remaining as follows
:
When the red B ink check light (and the ink bay light) is
flashing (and
INK LOW appears on the LCD display), the
indicated cartridge is almost expended. Make sure you have a
replacement cartridge. When the lights stay on and
NOT
ENOUGH INK
is displayed, the cartridge is expended. You
must replace the cartridge before you can continue printing.
Caution:
Leave the low or expended cartridge in the printer until you are
ready to replace it.
To prevent ink reporting errors, never replace the ink cartridges
with the printer turned off.
See page 3 for information on selecting the correct
replacement cartridges. Before you start, make sure the printer
is powered on. Then follow these steps to replace an ink
cartridge:
1. Note the color of the cartridge whose icon and abbreviation
is on or flashing. This is the cartridge you need to replace.
2. Press the ink cover button to unlock the ink bay, then open
the cover.
Note:
If the ink compartment doesn’t open when you press the button,
insert the end of a paper clip in the small hole on the upper left
corner.
3. Push in the expended cartridge to release it.
4. Remove the expended ink cartridge from the printer. It’s a
good idea to save a set of expended cartridges so you can use
them for transporting the printer, if necessary.
Warning:
Do not shake the expended cartridge, or ink may leak out. If ink
gets on your hands, wash them thoroughly with soap and water.
If ink gets in your eyes, flush them immediately with water.
HEAD
ALIGNMENT
PAPER THICKNESS
SELECT PAPER TYPE
SELECT THICKNESS
8 mil (0.2 mm), 4 to 60
mil (0.1 to 1.5 mm)
ALIGNMENT
AUTO
MANUAL
UNI-D, BI-D 2-COLOR,
BI-D ALL, BI-D #1,
BI-D #2, BI-D #3
UNI-D, BI-D 2-COLOR,
BI-D ALL
NETWORK
SETUP
NETWORK SETUP DISABLE, ENABLE
IP ADDRESS SETTING AUTO, PANEL
IP, SM, DG SETTING IP address, subnet
mask, default gateway
BONJOUR ON, OFF
INIT NETWORK
SETTING
Resets all network
settings
Full Ink low (flashing) Letters indicate
ink color
Half full Ink expended
20% or less Cartridge error or no cartridge
Menu Item Settings/Explanation
To Next Page
Loading...
