Epson 200 - Page 47

47
To use a memory setting you’ve saved on the projector:
Access the projector’s memory settings either from the remote control (see page 33) or by
using Cinema Color Editor as follows:
1. Select
Picture Quality, then click Memory management and choose Select.
2. Click the tab where the setting you want to use is stored (
Standard or Advance).
3. Select the desired memory setting, then click
Select. After a moment, your image appears
on the screen using the selected setting.
1. Select
Picture Quality
2. Click Memory
management
3. Click
Select
1. Select Standard
or Advance
2. Select the setting
you want to use
3. Click Select