EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 125
4.2.1.4 Removing the Printer Mechanism/Lower Housing
1. Remove the Rear Housing. (Refer to 4.2.1.2.)
2. Remove the Middle Housing. (Refer to 4.2.1.3.)
3. Remove the one screw 2) C.B.S 3
×10 (9±1kgf.cm) and four screws 4) C.B.P 4×12
(9±1kgf.cm) that secure the Printer Mechanism.
Figure 4-11. Screws That Secure the Printer Mechanism
4. Peel the Waste Ink Pad on the front right side, as viewed from the printer front,
from the Front Frame.
C A U T I O N
When removing the Middle Housing, fully push the hooks of the
Middle Housing into the printer inside to release the hooks since
the six cutouts of the Lower Housing are broken easily.
Refer to Figure 4-10, "Hooks That Secure the Left and Right of the
Middle Housing".
Fit the screws 4) C.B.P 4×12 (9±1kgf.cm) in the order shown in
Figure 4-11. (T.B.D.)
C.B.S 3×10
C.B.P 4×12
C.B.P 4×12
C.B.P 4×12
Lower Housing
Printer
Mechanism
Rear left side Rear right side
Front
left side
Front
right
side
Waste Ink Pad
Front Frame
To Next Page
Loading...
