Epson 2200 - Stylus Photo Color Inkjet Printer - Page 147

EPSON Stylus PHOTO 2100/2200 Revision B
DISASSEMBLY AND ASSEMBLY Disassembly 147
8. Lift the two overlapping Sus-Plates with pliers or like, and remove them from the
Carriage Unit.
Figure 4-60. Removing the Sus-Plates
9. Slide the Head Fastener to the left as viewed from the printer front, pull the right
end to the diagonal top right of the Carriage Unit, and remove the Head Fastener.
10. Slide the Printhead to the front as seen from the printer front, and remove and lift it
from the two hooks of the Carriage Unit.
Figure 4-61. Removing the Head Fastener
11. Remove the two Head FFC Guides from the Printhead, and remove the Printhead.
Figure 4-62. Removing the Printhead
When removing the Torsion Spring 66, hitch the longer end of the
Spring on the front center side hook of the Carriage Unit and on
the left side hook of the Carriage Unit, and the shorter end on the
Head Fastener.
Refer to Figure 4-59, "Reinstalling the Torsion Spring 66".
Figure 4-59. Reinstalling the Torsion Spring 66
Hook
Hook
Sus-Plate
Head Fastener
Hooks
Printhead
Head FFC Guides