Epson 2200 - Stylus Photo Color Inkjet Printer - Release Lever

EPSON Stylus PHOTO 2100/2200 Revision B
PRODUCTION DESCRIPTION Basic Specifications 25
1.2.5 Release Lever
On this printer, set the Release lever as indicated in the following table depending on
the used paper type.
Figure 1-12. Release Lever Positions
Table 1-9. Release lever Setting
Paper Release lever Position Gap Correction
Cut sheet, OHP, Label,
Roll paper
Front side position 0mm
Envelope, Board paper First step from front position +1.3mm
CD-R tray
*a
*a : When the CD-R tray is loaded, any position other than the second
step from the front position will result in a release lever error.
Second step from front
position
+2.7mm
- Far side position
*b
*b : The far side position of the Release lever is used when placing
thick paper (board paper) or CD-R tray. After placing thick paper
or CD-R tray, move the release lever to the appropriate position.
-
<Front side position>
<Second step from front position>
<Far side position>
<First step from front position>