EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 122
4. Disconnect the connector from the MOTOR ASSY., CR.
5. Remove the two screws that secure the MOTOR ASSY., CR and remove it.
Two C.C.S. 3 x 4 screws (6
± 1 kgf.cm)
Figure 4-44. Removing the screws from the MOTOR ASSY., CR
C H E C K
P O I N T
When removing the C.C.S. 3x4 screws that secure the MOTOR
ASSY., CR, use a stubby screw driver or put a screwdriver (with a
140mm or longer shaft is recommended) through the holes on the
main frame as shown in Figure 4-44.
Be sure to install the MOTOR ASSY., CR to the main frame so that
the label on the MOTOR ASSY., CR faces upward. See Figure
4-44.
A D J U S T M E N T
R E Q U I R E D
Whenever the MOTOR ASSY., CR is replaced,
the corresponding adjustments must be carried out.
See Chapter 5 "ADJUSTMENT" (p190).
MOTOR ASSY., CR
Connector
Overhead view
Label
C.C.S. 3x4
Put the screwdriver
through this hole.
To Next Page
Loading...
