EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 125
4. Release the cables of the LOCK, COVER, ASSY. from the two cable hooks.
See Figure 4-47.
5. Pull out the BASE, ENCLOSURE. (p110)
6. Release CN44 and CN51 connectors of the LOCK, COVER, ASSY. on the
BOARD ASSY., MAIN. See Figure 4-29.
7. Peel off the acetate tapes on the COVER, ENCLOSURE, ASSY. to release the
cables of the LOCK, COVER, ASSY., and remove the LOCK, COVER, ASSY.
See Figure 4-48.
Figure 4-47. Releasing the LOCK, COVER, ASSY. Cables (1)
Figure 4-48. Releasing the LOCK, COVER, ASSY. Cables (2)
Route the cables of the LOCK, COVER, ASSY., with other cables
and secure them with the acetate tapes as shown in Figure 4-48.
cable hooks
Left rear side of the printer
COVER, ENCLOSURE, ASSY.
acetate tapes
Left rear side of the printer
To Next Page
Loading...
