Epson 3800 - Stylus Pro Color Inkjet Printer - Page 127

EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 127
4.3.6.3 RELEASE SENSOR
1. Remove the HOUSING, UPPER. (p106)
2. Manually turn the SPUR GEAR, 22 shown in Figure 4-50 clockwise until the
FLAG, DETECTOR, RELEASE goes out of the detection part of the RELEASE
SENSOR (put the sensor into not-detecting state).
3. Disconnect the connector from the RELEASE SENSOR. See Figure 4-50.
4. Release the four hooks that secure the RELEASE SENSOR, and remove the
RELEASE SENSOR. See Figure 4-50.
Figure 4-50. Removing the RELEASE SENSOR
If the cables have come off the cable guides on the main unit while
removing the RELEASE SENSOR, be sure to route the cables
correctly referring to Figure 4-50.
Not Detected
Detected
SPUR GEAR, 22
RELEASE SENSOR
connector
Route through cable guides
hooks
RELEASE SENSOR FLAG, DETECTOR, RELEASE