EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 133
5. Remove the two screws (one each on the left and right) that secure the PLATE,
STOPPER, STACKERs and remove them.
Two C.B.S. 3 x 6 screws (9
± 1 kgf.cm)
Figure 4-57. Removing the PLATE, STOPPER, STACKERs
When securing the PLATE, STOPPER, STACKERs, be sure to put
their top ends into the each groove of the GUIDE, STACKER,
LEFT/RIGHT.
GUIDE, STACKER, LEFT
GUIDE, STACKER, RIGHT
Insert the top ends under the GUIDE,
STACKER, LEFT/RIGHT.
C.B.S. 3x6
PLATE, STOPPER, STACKERs
To Next Page
Loading...
