EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 166
5. Lift up the left side of the main frame, and remove the SPUR GEAR, 31.5 and the
COMPRESSION, SPRING, 2.25 from the main frame. See Figure 4-100.
6. Remove the TIMING BELT, PF from the pinion gear and the COMBINATION
GEAR, PF, DRIVE of the MOTOR ASSY., PF.
See Figure 4-101.
Figure 4-100. Removing the SUPUR GEAR, 31.5 (2)
Figure 4-101. Removing the TIMING BELT, PF
A D J U S T M E N T
R E Q U I R E D
Whenever the TIMING BELT, PF is replaced,
the corresponding adjustments must be carried out.
See Chapter 5 "ADJUSTMENT" (p190).
Left side
COMPRESSION,
SPRING, 2.25
SPUR GEAR, 31.5
pinion gear
(MOTOR ASSY., PF)
TIMING BELT, PF
COMBINATION GEAR, PF, DRIVE
To Next Page
Loading...
