EPSON Stylus Pro 3800/3800C/3850 Revision A
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 168
6. Remove the HARNESS, ENCODER, PF secured to the MOTOR, RELEASE,
ASSY., with the two-sided tape. See Figure 4-104.
7. Remove the three screws that secure the MOTOR, RELEASE, ASSY.
See Figure 4-105.
Three C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
8. Remove the TIMING BELT, PF from the pinion gear of the MOTOR ASSY., PF
and remove the MOTOR, RELEASE, ASSY.
Figure 4-104. Removing the HARNESS, ENCODER, PF
Figure 4-105. Removing the screws from the MOTOR, RELEASE ASSY.
A D J U S T M E N T
R E Q U I R E D
Whenever the MOTOR, RELEASE, ASSY., is replaced,
the corresponding adjustments must be carried out.
See Chapter 5 "ADJUSTMENT" (p190).
Left side of the printer
Two-sided Tape
HARNESS, ENCODER, PF
MOTOR, RELEASE, ASSY.
C.B.S. 3x6
C.B.S. 3x6
C.B.S. 3x6
MOTOR, RELEASE, ASSY.
TIMING BELT, PF
To Next Page
Loading...
