Epson AcuLaser C2900N - Page 272

Chapter 3 Removal and Replacement Procedures Revision B
Epson AcuLaser C2900N 3 - 18 Confidential
RRP1.8 COVER ASSY FRONT MG (PL1.2.1)
[Removal]
1) Remove the CASSETTE ASSY 250. (RRP2.1)
2) Open the COVER ASSY FRONT MG (PL1.2.1).
3) Remove the FEEDER ASSY DUP SFP STD. (RRP9.1) [Optional duplex only]
4) Open the TRANSFER ASSY (PL6.1.7).
Note: Cover the drum of the DRUM CARTRIDGE to avoid exposure to light.
5) Remove the DRUM CARTRIDGE. (RRP4.6)
Note: The FUSING part is very hot. Take added care not to get burned when performing the
service operation.
6) Remove the FUSER UNIT. (RRP6.1)
7) Remove the COVER ASSY WINDOW TNR. (RRP1.6)
8) Remove the COVER SIDE R. (RRP1.5)
9) Remove the COVER SIDE L. (RRP1.7)
10) Close the TRANSFER ASSY.
Note: When carrying out the work described below, leave the relay connector on the printer
harness side.
11) Release the relay connector from the
rib of the printer, disengage the connecter
(P/J271) of the HARN ASSY DUP RELAY
(PL1.2.13).
Note: This step is only for optional
duplex.