Epson AcuLaser C2900N - Page 273

Chapter 3 Removal and Replacement Procedures Revision B
Epson AcuLaser C2900N 3 - 19 Confidential
Note: When carrying out the work described below, leave the relay connector on the COVER
ASSY FRONT MG side.
12) Release the harness of the HARNESS
ASSY PNL A (PL1.1.12) from the rib of the
printer, disengage the connector (P/J5301)
of the HARNESS ASSY B (PL9.1.12).
13) Release the HARN ASSY DUP
RELAY and the HARNESS ASSY PNL A
from the hooks of the printer.
14) Remove the one screw (silver, 6mm)
that fixes the grounding terminal of the
HARN ASSY GND (PL1.2.22), release the
HARN ASSY GND from the GUIDE
HARNESS AC (PL8.2.6) and the hooks of
the printer.
Note: This step is only for optional
duplex.