1 - 23
Chapter 1 Troubleshooting
Epson AcuLaser C2900N
Revision B
Confidential
116
343
ASIC Error
Restart Printer
Error 116-343
Restart Printer
<ESS ASIC Fail>
The ASIC error occurred.
FIP-1.6
350
Network Error
Restart Printer
Error 116-350
Restart Printer
<ESS Network Communication Fail>
A communication error occurred between the On Board
Network and ESS firmware.
FIP-1.6
355
Network Error
Restart Printer
Error 116-355
Restart Printer
<On Board Network Fatal Error>
A fatal error occurred the on board network communication.
FIP-1.66
361
PCI Error
Restart Printer
Error 116-361
Restart Printer
<PCI Bus#0 Error Detected>
Connection error occurred between the PCI BUS port and the
port of peripheral devices.
FIP-1.67
362
PCI Error
Restart Printer
Error 116-362
Restart Printer
<PCI Bus#0 Host Bridge Controller Error>
Connection error occurred between the PCI BUS port and the
port of peripheral devices.
FIP-1.67
363
PCI Error
Restart Printer
Error 116-363
Restart Printer
<PCI Bus#1 Host Bridge Controller Error>
Connection error occurred between the PCI BUS port and the
port of peripheral devices.
FIP-1.67
366
PCI Error
Restart Printer
Error 116-366
Restart Printer
<PCI Bus#1 Error Detected>
Connection error occurred between the PCI BUS port and the
port of peripheral devices.
FIP-1.67
368
PCI Error
Restart Printer
Error 116-368
Restart Printer
<PCI Error Messages received from Bus#0-Device#1>
Connection error occurred between the PCI BUS port and the
port of peripheral devices.
FIP-1.67
369
PCI Error
Restart Printer
Error 116-369
Restart Printer
<PCI Error Messages received from Bus#0-Device#0>
Connection error occurred between the PCI BUS port and the
port of peripheral devices.
FIP-1.67
390
NV RAM Error
Restart Printer
Error 116-390
Restart Printer
<ESS NVRAM 1 SIZE And ID Check Fail>
Upon turning the power ON, an error occurred during checks
on consistency of the NVRAM size between the system-
required one and actual one and on consistency of the
recorded IDs.
FIP-1.6
Status
Code
Error Message
Status Contents
FIP to be
referred
LCD
To Next Page
Loading...
