46
EpsonNet WinAssist Configuration Utility
❏ If Auto is selected but no DHCP server is installed in your
system or on your network and the Use a private IP address
when an IP address cannot be assigned by the DHCP
server check box is cleared, the Internal Print Server uses
“192.168.192.168” as the default IP address.
❏ If Auto is selected for Get IP address, every time you turn on
the printer you need to change the printer port setting
accordingly. Therefore, for TCP/IP printing we recommend
selecting Manual and setting the IP address manually.
8. When setting the IP address using the ping command, select
Manual and then select the Set by PING check box.
Note:
Be sure to clear the check box when not using ping; this prevents
anyunexpectedchangeoftheIPaddressbyEpsonNet
WebManager.
9. When you select Manual, assign the IP address, the subnet
mask, and the default gateway. Be sure to give an IP address
that does not conflict with any other device on the network.
Note:
❏ The default value for the IP address, subnet mask, and default
gateway are 192.168.192.168, 255.255.255.0, and
255.255.255.255 respectively.
❏ If there is a server or a router which functions as a gateway,
enter the IP address of the server or the router for the gateway
address. If there is no gateway, leave the default values there.
10. Select theUse a private IP address when an IP address cannot
be assigned by the DHCP server check box to get a private
address between 169.254.1.1 and 169.254.254.254
automatically when an IP address cannot be obtained by the
DHCP server.
To Next Page
Loading...
