Epson Aculaser C9200N - Page 263

EPSON AcuLaser C9200N Revision D
DISASSEMBLY AND ASSEMBLY Main Unit Disassembly/Reassembly 263
Confidential
Make sure following things when installing the High Voltage Unit (HV1).
 Terminal end surely contacts (Refer to Figure 1).
 Tab [5] surely set up (Refer to Figure 2).
Terminal end position
4038F2C087DA
Figure 1
Figure 2
 Be cautious not to install the wrong Screw because two types of Screws [2] are
used.
• M Mark: Screws for installing metallic parts (Space between thread is small).
• P Mark: Screws for installing plastic parts (Space between thread is large).
P Mark
M Mark