Epson Aculaser C9200N - Page 321

EPSON AcuLaser C9200N Revision D
ADJUSTMENT Firmware Update 321
Confidential
UPDATE METHOD 1
 Required Tool
 Computer
 USB cable
 Firmware Update Tool
 Control Panel Special Operation
Required
Step Explanation LCD Panel
1 Print a Configuration Status Sheet, and check
the current version.
---
2 After turning the power off for both the
printer and computer, connect them with a
USB cable.
Before connecting the USB cable,
make sure to disconnect other
interface cables from the printer.
---
3 Turn the computer on and copy the firmware
data file (CRB format) to any directory of the
computer.
---
4 Turn the printer ON while holding down the
[Start/Stop], [Job Cancel], and [Down]
buttons.
(The printer will start up in “Controller
Firmware Update Mode”.)
5 Start up the Firmware Update Tool.
Specify the port and the program update file
on the selection window of the tool.
---
6 Click [Send] on the Firmware Update Tool
screen.
7 “Completion” pop-up window will be
displayed when the data transfer is finished.
Click [OK].
Confirm that both the old and new firmware
versions are displayed on the LCD, and press
the [OK] button on the control panel to start
the program update.
Step Explanation LCD Panel