20
D Secure the projector to the setting plate
(1) Loosen the two screws and remove the cable cover from the projector.
(2) Insert the slide plate into the setting plate from the interface side of the projector (
A).
Align the marks on the projector and the setting plate (
B).
(3) Tighten the two M5 x 12 mm hexagon socket head cap bolts (
C).
Cable cover
Screws (2)
Projector
interface side
M5 x 12 mm hexagon
socket head cap bolts (2)
Marks
Bolt positions
Slide plate
If you use adhesives to prevent the screws from loosening or things such as lubricants or oils
on the slide plate, the case may crack and cause the projector to fall, resulting in personal
injury or property damage. Do not use adhesives, lubricants, or oils to install or adjust the
setting plate.
Warning
To Next Page
Loading...
