Epson BrightLink 455Wi - Using the Easy Interactive Pen Driver; System Requirements for Interactive Pen Driver; Checking Interactive Pen Connection Status

4 Introduction
■ Try pressing the Source Search button on the remote control.
6. Launch the Easy Interactive Driver on your computer. You should see the
pen icon in the lower right corner of your screen (Windows
®
) or in the
Dock (Mac OS
®
X). If you don’t see the icon, see page 13 or do one of the
following:
■ Windows: select or Start > All Programs or Programs > Epson
Projector
> Easy Interactive Driver.
■ Mac OS: open the Applications folder, then select the Easy Interactive
Driver
icon.
7. Calibrate your system (see page 13).
■ Windows: click the pen icon in the system tray on your taskbar
(lower right corner of your screen), then select
Calibrate (Normal).
■ Mac OS X: click the pen icon in the Dock, select Calibrate from
the menu bar, then select
Calibrate (Normal).
■ After you read the message about calibration,
click
OK.
■ Use the interactive pen to touch each flashing green
circle as it appears. Continue until all the circles stop
flashing and turn black.
■ Hold the pen at an angle, and make sure you are not casting a shadow on
the pen.
■ If you make a mistake, press Esc on your computer keyboard and restart
calibration.
8. Launch Easy Interactive Tools (see page 17).
■ Windows: select or Start > All Programs or Programs > Epson
Projector
> Easy Interactive Tools.
Mac OS X: open the
Applications folder, then select Easy Interactive
Tools
> Easy Interactive Tools.