Epson BrightLink 455Wi - Connecting to a Wired Network (Continued); DHCP and IP Address Settings

102 Using the Projector on a Network
9. Do one of the following:
■ If your network assigns addresses automatically, turn on the
DHCP setting.
■ If your network does not assign addresses automatically, turn
off
DHCP and enter the projector’s IP Address, Subnet
Mask
, and Gateway Address, as needed.
To enter numbers, use the arrow buttons on the remote
control to select each number on the screen, then press the
Enter button. When you’re finished entering an address in
the network menu, highlight
Finish, then press the Enter
button.
10. Press
Esc to return to the previous menu.
11. To prevent the IP address from appearing on the standby screen,
set the
IP Address Display setting to Off.
12. When you’re done making these changes, press
Esc, select
Complete and press Enter. Then select Yes and press Enter
again to save your settings.
Press
Menu to exit the menu system.