Epson BrightLink 475Wi - Connecting to a Computer for VGA Video; Connecting to a Computer for HDMI Video and Audio

37
English
2. Insert and turn the hexagonal shaft at the top of the mount arm into the slot on the wall plate ( ).
3. Insert and turn the M8 hexagon bolt at the bottom of the mount arm into the wall plate ( ).
4. Secure the mount arm to the wall plate by tightening the supplied M6 × 20 mm cross recessed head
shoulder screws (×3) with the No.3 cross-head screwdriver ( ). Then, loosely tighten the M6 × 20
mm hexagon shoulder bolt supplied ( ).
❏ Make sure the Touch Unit connection cable is not wired into the wall with the other cables.
❏ Take care not to trap the cables between the mount arm and wall plate.
Caution
Hexagonal shaft
M8 hexagonal bolt
Touch Unit connection cable
M6 × 20 mm cross recessed
head shoulder screws (×3)