15
English
3. Attach the Touch Unit and securing plate to the installation plate with the M4 × 12 mm hexagon socket
head cap bolts (×2) supplied.
Tighten the bolts to the securing plate with the supplied hexagon wrench.
4. Measure the distance from the wall to the surface of the whiteboard (f).
❏ If the distance from the wall to the surface of the whiteboard is greater than
2 inches (51 mm), you must install the Touch Unit on the whiteboard.
❏ If the frame of the whiteboard extends more than 0.1 inch (3 mm) away from the
board surface, you must install the Touch Unit on the whiteboard.
To Next Page
Loading...
