Epson BrightLink Pro 1470Ui - Installing the Control Pad; Installing the Control Pad (Brightlink 697 Ui and Brightlink Pro 1450 Ui;1460 Ui;1470 Ui); Check the Installation Location

40
4 Installing the Control Pad (BrightLink 697Ui and
BrightLink Pro 1450Ui/1460Ui/1470Ui)
You must install the projector before installing the Control Pad.
Follow the steps below to install the Control Pad and connect to the projector.
Check the installation location
Make sure there is enough space surrounding the Control Pad to easily connect or disconnect cables.
When installing the Pen Stand, do not block the groove in the front cover of the Control Pad.
The Control Pad should only be connected to the BrightLink 697Ui and BrightLink Pro 1450Ui/
1460Ui/1470Ui. Do not connect the Control Pad to any other projectors.
Caution
2 in (50 mm)
3.9 in
(100 mm)
3.9 in (100 mm)
3.9 in
(100 mm)