Epson CO-FH02 - Saving Settings to a USB Flash Drive

63
The following settings will not transfer between projectors if you set the Batch Setup Range setting to
Limited:
• Password Protection settings
Saving Settings to a USB Flash Drive
Transferring Settings from a USB Flash Drive
Saving Settings to a Computer
Transferring Settings from a Computer
Parent topic: Adjusting Projector Features
Saving Settings to a USB Flash Drive
You can save the projector settings you want to transfer to a USB flash drive.
Note: Use an empty flash drive. If the drive contains other files, the transfer may not complete correctly.
The flash drive must use the FAT format and cannot have any security features.
1. Turn off the projector and unplug the power cord from the projector's power inlet.
2. Insert the flash drive into the USB-A port.
Note: Connect the flash drive directly to the projector. Do not use a hub or your settings may not be
saved correctly.
3. Press and hold the return button on the remote control as you connect the power cord to the
projector.
4. When the status light turns on, release the return button.
The light flashes to indicate that settings are transferring to the flash drive. When the light stops
flashing, it turns blue and the projector enters standby mode.
Caution: Do not unplug the power cord or remove the flash drive while the light is flashing.This
could damage the projector.
Note: If the status light flashes orange, the batch setup file may be corrupt or the cable is not
connected correctly. Disconnect the USB cable, then unplug the projector and try the procedure
again. If the problem continues, unplug the projector and contact Epson for help.
5. Once the projector enters standby mode, remove the flash drive.