Epson DFX-9000 - Fatal Errors

Epson DFX 9000 Revision B
Troubleshooting Error and warning messages 103
3.2.1 Fatal errors
3.2.1.1 List of fatal errors
Note: Error codes 00, 10, and 19 ~ 29 are not supported
3.2.1.2 Fatal error log
Use the adjustment program to retrieve the error log information stored
in non-volatile memory on the main board. Refer to Chapter 5,
Adjustment, Troubleshooting fatal errors (p.255).
Table 3-2. List of Fatal Errors
Fatal
Error
Code
Description Reference
01 LES Error Page 106
02 CR Driver Error Page 106
03 CR Horizontal Position Error Page 106
04 PF Driver Error Page 107
05 CR Error Page 107
06 High Volt Error Page 107
07 Low Volt Error Page 107
08 Over Load Error Page 107
09 FAN1 Driver Error Page 108
0A FAN2 Driver Error Page 108
0B FAN3 Driver Error Page 108
0C FAN4 Driver Error Page 108
0D No Head Error Page 108
0E Head Driver Error Page 108
0F APTC Error Page 109
11 Ribbon Feed Driver Error Page 109
12 Ribbon Jam Error Page 109
13 HCPP Driver Error Page 110
14 HCPP Error Page 110
15 OC Driver Error Page 110
16 OC Error Page 110
17 PC Driver Error Page 111
18 PC Error Page 111
30 CG Error Page 111
31 EEPROM Compare Error Page 111
C H E C K
P O I N T
To access the printer with the Adjustment Program while in
a fatal error state:
1. Turn off the printer
2. Turn it on again while holding down the panel buttons
[Front/Rear] + [Font] + [Pitch]
This places the printer in Error Analyzing Mode.
Table 3-2. List of Fatal Errors
Fatal
Error
Code
Description Reference